- CIPS Newsletters
Radiology and Imaging Sciences
Nuclear Medicine Procedures
DEXA stands for Dual Energy X-Ray Absorptiometry (or Densitometry). DEXA is a procedure that measures the amount of bone, muscle, and/or body fat.
The DEXA determination of bone density or body composition (muscle and fat composition) is performed with an instrument that uses low-energy X-rays. For bone density measurements, scans are typically performed of the lumbar (lower) spine, the hip, and the wrist. For body composition measurements, a scan of the entire body is performed. The DEXA instrument is very open, consisting of a table and scanning arm (in the shape of a ‘C') that houses the X-ray tube on one end of the arm and the detector on the other end.
There is no specific patient preparation for these studies. However, please consider the following regarding patient eligibility for DEXA studies:
- DEXA studies cannot be performed if the patient has had a nuclear medicine study within 1 week or an X-ray procedure using contrast within 72 hours. Therefore, DEXA studies should be scheduled before other X-ray or nuclear medicine procedures. If these other procedures are performed before the DEXA procedure and the time elapsed does not meet our protocol, the DEXA procedures will not be performed, and the study will be rescheduled.
- A woman of child-bearing age must have pregnancy ruled out before undergoing the test.
Often, this means having a pregnancy test performed within 1 week of the DEXA procedure.
The length of time in the clinic will depend on the number of procedures that are performed. Usually, the appointment is for either 1/2 hour or 1 hour.
The patient should wear light clothing to the clinic so he/she can change into a surgical scrub uniform for the study. After changing into a scrub uniform, the patient will have weight and height measured. For such measurements and for scans, a patient will remove shoes. The individual scanning procedures are performed with the patient either lying on top of or sitting next to the scanning table.
For each scan, the technologist must perform two steps. The first step is the scan (scan acquisition); the second step is analysis of the scan (scan analysis) to determine the information contained within the scan. The DEXA scans are therefore more complicated than standard X-rays. The DEXA scan is performed to actually measure the amount of bone, muscle, or fat.
After the technologist has completed and satisfactorily analyzed the scans, the patient can change back into street clothes and leave the clinic.
All scans are reviewed by one of the Nuclear Medicine physicians. A report of the DEXA scan results will be entered into the hospital's computer and record system. This is usually done the same day as the scan.
NOTE: PDF documents require the free Adobe Reader.
This page last updated on 06/22/2017